Leave the configuration as default, as the X-NUCLEO-SRC1M1 BSP will reconfigure it. In the Analog section, enable ADC1 peripheral channel 0. I think of it as poor practice to initialize the I2C peripheral on default. To do it, an ADC needs to be configured to measure the VBUS voltage and current.Īs we are going to use the X-NUCLEO-SRC1M1 BSP, the ADC configuration does not need to be done in CubeMX.Īs we need the ADC LL drivers for it to work properly, we still need to configure the ADC in CubeMX for it to include the driver files, but the actual configuration and init function will not be called in our project. When I get a chance Ill try it on an F4 board and see if I get same result. Used values and associated decoding for this project have been added to the table.įor the Power Delivery stack to work, VBUS needs to be monitored. Qwiic cables (4-pin JST) plug easily from development boards to sensors. The following table is extracted from USB Power Delivery Specification, Table 6-9 Fixed Supply PDO - Source. Like the Serial Peripheral Interface (SPI), it is only intended for short. USB Host Shield is an inexpensive development board designed to be used in embedded. As a target selection, choose the NUCLEO-G0B1RE from the Board Selector Tab Home / I2C Shield for Adafruit Huzzah ESP8266 Integrated USB and I2C. Open STM32CubeIDE and create a New STM32 Project. This tutorial shows how to use the I2C interface on the STM32 devices. After much trial and error, I took another Mac I had, fresh install of MacOS (10.13.6), fresh install of Arduino (1.8. Deprecated: use 100 machine.KHz or 400 machine.KHz instead. Normally either 100 kHz, or 400 kHz for high-speed bus. 9 Establish the first explicit contract const ( TWIFREQ100KHZ 100000 TWIFREQ400KHZ 400000 ) TWIFREQ is the I2C bus speed.2.9.3 Configure UCPD monitor firmware responder for debug.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |